Amps
[Top] [All Lists]

Re: [Amps] How to tune an FL-2100B

To: Tom W8JI <w8ji@w8ji.com>, amps@contesting.com
Subject: Re: [Amps] How to tune an FL-2100B
From: Dan Wright <dwright12@neb.rr.com>
Date: Tue, 04 Jul 2006 07:55:15 -0500
List-post: <mailto:amps@contesting.com>

Thanks for the nice reply, Tom....

>You actually should load that FL2100 at full Yeasu drive, but that 
>would be too much for the little FL2100 for very much time. The 
>FL2100 is a terrible AM linear for the FT101.

goody....scratch that idea....

>PEP from the FT101EX could be as much as 150 watts. That means the 
>FL2100 needs to be fully loaded at 150 watts of CW carrier drive, 
>and that is just too much.  You'd need an attenuator pad between the 
>amp and rig or really watch your control settings.

Why can't I just reduce the drive on the '101 to 25 watts and drive 
the amp with that?

 From brief experience:

It looks like if I drive the amp with 25 watts, I get around 125 -130 
watts out of the
amp. Four times that (PEP) is 520 watts, well below the 1200 watts PEP rating
of the amp.

What am I missing here?

>Load the amp heavy enough to handle peaks without saturating or 
>over-dissipating the tubes. To do that safely, you will need to add 
>two more tubes.

I see....

>73 Tom

73 to you as well, de Dan 


-- 
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.1.394 / Virus Database: 268.9.8/380 - Release Date: 6/30/2006


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>