On Jul 9, 2006, at 5:56 AM, Gene Bigham wrote:
> I have never used one of these, what do you do? Hook it up to the
> item to be checked and begin increasing the Kv and watch for
> current to flow at some point?
Bingo
> Then note the voltage at which the current flows?
Correct. I usually use 2uA as the dividing line.
> I would assume such a device is very limited in its current ability.
If it wasn't, it' would be good for arc-welding.
> Thanks for info.
> Gene KB0GU Bigham
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
R L MEASURES, AG6K. 805-386-3734
r@somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|