Hi Dick,
Any material I wish to use as an insulator I test in a microwave oven
before.
When you run high power with coils of 2,5mm wire diameter, I am pretty sure
that acryl will deform by the heat generated in the wire, no problem with
the voltage.
73
Peter
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Dick
Hi,
I want to run a high power bandpass filter behind an HF-amplifier.
The filter should work with powers upto 1kW, which means that high voltages
can be present in the circuit.
It's the W3NQN design, but instead of toroids I'm using air wound coils ,
unfortunatly I have only 2.5mm thick wire.
To add stability to the coils I'm planning to use a little plexiglas plate
(5-6mm) with hole's in it
through which the coil wire is wound.
I wonder if this is possible, because there might be high voltage across the
coil (several kV's),
in case of a mismatch. What about the plexiglas? Can it witstand this?
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|