Green and green are 6.3vrms (across them). Green/yellow is the secondary
center tap, which would be 3.15vrms to either of the green wires.
-WB2WIK/6
-----Original Message-----
From: OTAKEBI@aol.com [mailto:OTAKEBI@aol.com]
Sent: Wednesday, October 04, 2006 3:20 PM
To: amps@contesting.com
Subject: [Amps] Need help with Hammond filament transformer.
I am setting up a separate 6.3 VCT filament transformer for filament cur.
from a power supply to a transmitter.
I have a Hammond transformer but I need an Elmer to tell me how to hook it
up.
I don't have documentation but have to go by color codes on wires.
I can tell that the two wires that are black are the primary wires and
should go to the 115 volt line to get power into the transformer.
Now on the secondary I have three wires.
A green wire, a green/yellow wire, and another green wire.
Which of those three wires should go to filament on the plug that goes to
the transmitter and which should go to filament common and where does the
third
wire go to?
Thanks for any help in advance.
Dan/N4VET
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.407 / Virus Database: 268.12.13/463 - Release Date: 10/4/2006
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.407 / Virus Database: 268.12.13/463 - Release Date: 10/4/2006
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|