Andy:
Are the filaments on the 2 tubes in series or parallel? If they are
in parallel, you likely have just lost the filament on the one tube and
the filament transformer is likely all ok. Fern
----- Original Message -----
From: "Andy Diethard Hansen" <HB9CVQ@hispeed.ch>
To: <amps@contesting.com>
Sent: Saturday, December 09, 2006 4:35 PM
Subject: [Amps] TL922-one tube dead?
>
> Hi Group,
>
> My modified TL-922 (230V/50Hz) created some humming noise in the past
> month
> (may be filament transformer-somehow remaining after PA switched off)
> before
> going to half power after 15 years, yesterday. Some smell came from
> the amp.
> The noise now is very strong when switched on and will reduce a
> little
> after a while.
> Looked from the outside first like some arcing on the board right next
> to
> the left upper corner. One tube is now not heating anymore (left from
> front). Grid Idle/plate current and power out are down to 50% normal
> in CW
> and SSB. HV is normal. I assume one tube has gone to heaven (matched
> pair?-3-500Z orig.)
>
> Questions:
>
> Where do I get quickly a reasonably priced (set?) of tubes and a
> FILAMENT Transformer???
>
> Any other advice/comments/experience? tnx for help
>
> Andy HB9CVQ
> www.qrz.com/hb9cvq
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> --
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.409 / Virus Database: 268.15.15/580 - Release Date:
> 12/8/2006
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|