Good idea. This site is great for innovative ideas.
Thanks
**************************************************
--- Chris Howard <chris@yipyap.com> wrote:
>
> I have a large AM transmitter that uses HDVL B&W
> coils in the output.
> When I got the thing, a couple of the coils looked
> like they had been
> sat on or something.
>
> I was able to use nylon string to sort of sew up the
> wayward coils,
> straightening them out and making an 'X' of the
> nylon string between
> the turns about 3-4 different places around the
> circumference. I could
> regulate how close the turns got by how hard I
> pulled on the string.
> When done, I used 5min epoxy to seal the nylon
> string in place.
>
> It seems to have worked pretty well.
>
> I suppose you could also use some weedwhacker nylon
> line as
> spacers if necessary, to get the right spacing.
>
> Chris
> w0ep
>
>
>
> On Thu, 2006-12-14 at 08:09 -0800, aborg wrote:
> > Hello Group,
> >
> > Anyone have any tips, resources, ideas or
> templates
> > to restore the coil separating ribs for the B & W
> tank
> > coils ? I called B & W they acted liked I had the
> > plague. I should have come here first anyway.
> > Thanks
> >
> >
> >
> >
> >
> >
> >
> > Mike-KK4MS
> > a_borg@yahoo.com
> >
> >
> >
> >
>
____________________________________________________________________________________
> > Cheap talk?
> > Check out Yahoo! Messenger's low PC-to-Phone call
> rates.
> > http://voice.yahoo.com
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
>
>
Mike-KK4MS
a_borg@yahoo.com
____________________________________________________________________________________
Yahoo! Music Unlimited
Access over 1 million songs.
http://music.yahoo.com/unlimited
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|