Hi Tom,
What you're saying makes sense. I have an IC-746 driving an IC-2KL and that
amp needs about 35-40 watts drive. I'm reducing the drive but maybe that's
not the way to go. Any ideas?
73 Bert, VE3OBU
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Tom W8JI
Sent: Saturday, March 17, 2007 1:53 PM
To: Steve Flood; amps@contesting.com
Subject: Re: [Amps] drive power
> I understand that my 100-w tranceiver should be run at maximum output
> to the amp input. Apparently, this requires a grounded-grid setup to
> accomodate the
> relatively high drive level. Yet there seems to be many
> amps that are grid-driven that require very small amounts of drive
> power. Are these amps not designed to be used modern transceivers?
> Are they commonly driven by homebrew low-power exciters?
If an amp requires very low drive and is driven by a 100 watt exciter, it is
a very poor system.
Sometimes people think it improves distortion, but it often does just the
opposite.
73 Tom
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.446 / Virus Database: 268.18.13/725 - Release Date: 3/17/2007
12:33 PM
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.446 / Virus Database: 268.18.13/725 - Release Date: 3/17/2007
12:33 PM
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|