I purchased a used HF amp with a 4-1000A but no blower. To verify that the
blower I have is adequate I would like to measure seal temperatures. I
believe that this can be done using Tempilaq. How successful is doing that?
The
maximum seal temperatures are 150C for the base and 200C for the plate. To
be conservative, I expect to use tempilaq laquer values well below those
temperatures. What values of temperature do you usually experience with an
adequate blower? If you have the model of such a blower that would be helpful
too.
Thanks. Bob W7LR w7lr@aol.com
************************************** Get a sneak peek of the all-new AOL at
http://discover.aol.com/memed/aolcom30tour
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|