Amps
[Top] [All Lists]

Re: [Amps] Alpha 76 PI-EL modification for WARC bands

To: "Joe Subich, W4TV" <w4tv@subich.com>,"'Andy Pfeiffer'" <andy.pfeiffer@magellan.aero>,<amps@contesting.com>
Subject: Re: [Amps] Alpha 76 PI-EL modification for WARC bands
From: "jeremy-ca" <km1h@jeremy.mv.com>
Date: Tue, 18 Sep 2007 15:28:21 -0400
List-post: <mailto:amps@contesting.com>
Use a B&W 802 or an Ameritron.

Carl
KM1H



----- Original Message ----- 
From: "Joe Subich, W4TV" <w4tv@subich.com>
To: "'Andy Pfeiffer'" <andy.pfeiffer@magellan.aero>; <amps@contesting.com>
Sent: Tuesday, September 18, 2007 2:17 PM
Subject: Re: [Amps] Alpha 76 PI-EL modification for WARC bands


> 
>> it tune on
>> 12 using 10 position but perhaps modification would be better.
> 
> Be very careful using the Alpha 76 series amplifiers on 12 meters. 
> ETO used a plate choke that was intentionally resonant around 26 MHz 
> to prevent use of the amplifiers on 11 Meters.  The amplifier has 
> a well documented tendency to blow the choke on 12 meters. 
> 
> 73, 
> 
>   ... Joe, W4TV 
>  
> 
> 
>> -----Original Message-----
>> From: amps-bounces@contesting.com 
>> [mailto:amps-bounces@contesting.com] On Behalf Of Andy Pfeiffer
>> Sent: Tuesday, September 18, 2007 12:45 PM
>> To: amps@contesting.com
>> Subject: [Amps] Alpha 76 PI-EL modification for WARC bands
>> 
>> 
>> Hi there
>> Is anyone has modification to Alpha 76 PI-EL and Plate choke to put it
>> on 30, 17 and 12 Meters.
>> It tune on 30 using 20 position, on 17 using 20 position and 
>> it tune on
>> 12 using 10 position but perhaps modification would be better.
>> 
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>> 
>> 
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>