In a message dated 11/25/2007 1:16:16 P.M. Eastern Standard Time,
km1h@jeremy.mv.com writes:
Hello all, first time posting but been reading for a while. This is an
> interesting question. My SB-200 seems to have the input that appears to be
> off. Every time I try to tune, I have to use the radios internal tuner to
> get an swr that's acceptable to get the drive just to get 500 watts out
> put on the linear.
> Not to hijack the thread, but is there a way to check the inputs on the
> SB-200 with a MFJ tuner or Autek VA1 vector analyst.
> Thanks Tom WZ9L
I'll bet you are using an ICOM radio, there radios have a much too sensitive
SWR foldback circuit. I have owned almost a hundred SB-200's and never had
such problem using Yeasu radios driving them. Lou
**************************************Check out AOL's list of 2007's hottest
products.
(http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001)
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|