I start off with a few watts of drive...dip the grid, tune for maximum
smoke then incrementally bump up the drive and repeat...
The 8877 amp that I just built for 2m tunes up just fine like that. Is
there a different procedure for the HF/ the 811A's ?
Gudguyham@aol.com wrote:
> Good but how are you loading the amp?
>
>
>
> ------------------------------------------------------------------------
> Check out AOL Money & Finance's list of the hottest products
> <http://money.aol.com/special/hot-products-2007?NCID=aoltop00030000000001>
> and top money wasters
> <http://money.aol.com/top5/general/ways-you-are-wasting-money?NCID=aoltop00030000000002>
>
> of 2007.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|