Perhaps some of the Amps Reflector experts out there can help with an amplifier
construction project problem! Recently completed the fourth in a series of
similarly constructed Drake L4B/8877 retrofits. All have upgraded, Hipersil,
step start, higher voltage supplies. All the projects utilized basically the
OEM Drake bandswitch tank circuit components and to this point have been well
worth the effort making 2200w output. Unfortunately, the last one is giving me
grief. On the 40/80m band, I?m unable to load beyond the 600w output range
(10w of drive) without experiencing RF ?fireworks? in the plate tune capacitor.
This plate cap was replaced with a wide spaced, heavy duty unit because the
original Drake cap initially exhibited the same characteristics; and I
thought the replacement would solve the problem. Didn?t help! I?m able to
Variac control the plate voltage and the problem appears not to be voltage
initiated. Oddly, on 20m, the amp (4+KV plate voltage) develops 1800w output
(Bird Meter/dummy load) without a whimper with only 30w of drive. To address
the problem, I tried a variety of parasitic choke combinations from no choke,
?U? shaped, and the typical coil/resistor combination (all with 50ohm
non-inductive resistors). The latter style did help only slightly until a
higher level of output was tried. I substituted a single 1000pFd blocking
capacitor for a pair of parallel 1000pFd units with somewhat better results.
However, tuning remains critical on the lower bands and output remains about
the 600 watt level with accompanying flashing. RF ?fireworks? manifest
itself within the confines of plate tune capacitor. The flashing is either
plate to plate or plate to ground and usually never in the same location. In
this installation, I used the Drake HV plate choke since my custom wound 1?
porcelain units have essentially the same configuration and electrical
characteristics. Apparently the stable/unstable boundary line is very critical
and really hasn?t changed much with any of the component changes. Incidentally,
higher output can be achieved on the lower bands but only with fast tune/load
capacitor combinations and lots of unsettling flashes and noise. Not a
comfortable scenario especially with the price of a replacement tube. Meshing
of the capacitor plates are all normal for the three bands tested. I have
several spare tubes but did not make any substitutions as yet. When I regain
some motivation, I plan to pad the plate tune cap with small increments of
capacitance but the outcome is uncertain. I?ve already prepared a posting for a
0-300 pFd vacuum variable. That may or may not help but at this point I?m at a
loss. Incidentally the positioning of all the components are close clustered
so the typical caveats have been addressed. After reading my abbreviated tale
of tribulation, is there anyone out there who may recognize where I may focus
next? Any help would be appreciated. I sense I?m close to getting the old gal
up and running. For the Drake purists, I exercised extreme care to keep the
amplifier OEM so it appears to be a factory stock unit. Regards, Ron W2CQM/3
_____________________________________________________________
Click to find out what your future holds.
http://thirdpartyoffers.juno.com/TGL2121/fc/Ioyw6i3lzGqDM3VjJclP1GXWOgZi27WyrX019FxhDE5I3wsNfewtvk/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|