What will make it better after 30 seconds than what it would be after a
second or two of turning on the power switch?
73
Gary K4FMX
> -----Original Message-----
> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
> Behalf Of jeremy-ca
> Sent: Wednesday, January 23, 2008 12:06 PM
> To: W5CPT; Amps
> Subject: Re: [Amps] Warm up time for SB-200?
>
> Its prudent to allow about 30 seconds of on time before transmitting.
> Instant on aint exactly instant.
>
> Carl
> KM1H
>
>
> ----- Original Message -----
> From: "W5CPT" <w5cpt@bellsouth.net>
> To: "Amps" <Amps@contesting.com>
> Sent: Wednesday, January 23, 2008 11:18 AM
> Subject: [Amps] Warm up time for SB-200?
>
>
> > Is there a recommended warm up time for a Heathkit SB-200? The manual
> does
> > not say anything about it.
> >
> > Clint - W5CPT
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|