There`s a good possibility of future problems because the plate transformer
may not be rated for capacitor input filtering with the increased heating
effect.Also,the hv supply couldn`t be nearly as regulated as with the tuned
choke design Henry intended for their amps to be powered with.I don`t think
plate tune spacing would be an issue for Henry as most things they built
were with much over-kill..Jim,K7RDX..
----- Original Message -----
From: "Vic K2VCO" <vic@rakefet.com>
To: "Kevin LaHaie" <klahaie@centricata.com>; "Amps reflector"
<amps@contesting.com>
Sent: Friday, March 21, 2008 1:15 PM
Subject: Re: [Amps] Henry 2K-3 PS Mod
> Kevin LaHaie wrote:
>> Hello
>>
>> I am planning to convert the stock P/S in my Henry 2K-3 to a purely
>> capacitor filter primarily to increase the HV, but in addition some way
>> that capacitor filters are better for SSB. My other, newer Henry's (2K
>> Classic X and 3K Classic X Mark II) still use the choke filter design,
>> albeit with higher voltages, and never had a complaint!
>
>> 1. What changes to the biasing is necessary with the higher plate voltage
>
> According to the 3-500z data sheet
> <http://home.c2i.net/clank/ham/pa/3-500z.html>, class AB2 operation at
> 3000v requires a cathode voltage of +10v, with 3500v requiring +15v. The
> 2K3 schematic shows a 1N2808B zener in the cathode circuit, which is a
> 10v 50w part.
>
> I would keep a couple of other things in mind. Gain will be higher with
> higher plate voltage, so any tendency to instability will be magnified.
>
> I don't know what the plate spacing of the tuning capacitor is, but make
> sure it is enough for the increased voltage.
>
> I am not sure this is a good idea. Why do you want to do this?
>
> --
> 73,
> Vic, K2VCO
> Fresno CA
> http://www.qsl.net/k2vco
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> --
> No virus found in this incoming message.
> Checked by AVG.
> Version: 7.5.519 / Virus Database: 269.21.8/1337 - Release Date: 3/20/2008
> 8:10 PM
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|