Amps
[Top] [All Lists]

Re: [Amps] Wire

To: <amps@contesting.com>
Subject: Re: [Amps] Wire
From: "Gary Hinson" <Gary@isect.com>
Date: Tue, 29 Jul 2008 14:18:43 +1200
List-post: <amps@contesting.com">mailto:amps@contesting.com>
> I often see  a note about the use of Teflon wire for baluns . 
> Does any know
> a reason why  TefzelR ETFE insulated wire would not be as 
> good or better
> because the  dielectric strength is even higher and the main 
> reason it I
> have some wire on hand. Ref wire type M22759/16   (12ga)

Hi Rich.

There *may* be some cunning impedence reason but my guess is that the main
driver for using Teflon insulated wire is good HV insulation coupled with
low diameter.

Personally, I find the stripped out inner conductor line from strag ends of
decent coax to be more than adequate for mine.  And free.

Mechanical strength and water resistance of the whole job is far more
important to me than the RF performance.  Corrosion and mechanical stress
kills my baluns, not the wrong kind of insulation.  Mind you, I do use
appropriate size and types of core given the power level and band.

73,
Gary  ZL2!FB

http://www.g4ifb.com/html/homebrew.html


_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>