Amps
[Top] [All Lists]

Re: [Amps] SB-220 saga continues

To: <amps@contesting.com>
Subject: Re: [Amps] SB-220 saga continues
From: "Mike" <noddy1211@sbcglobal.net>
Date: Sat, 8 Nov 2008 21:08:32 -0800
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Yup, sounds like the SB-220's 110v zapped the rig maybe.

Mike

-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of W7RY
Sent: Saturday, November 08, 2008 8:42 PM
To: ke1fo@arrl.net; amps@contesting.com; YCCC
Subject: Re: [Amps] SB-220 saga continues

Sounds like the relay in the amp is energizing when you turn on the amp. My
guess is that your relay contacts in your transceiver are stuck (shorted). 

Unplug the PTT cable from the amp or the rig. I but it works fine then. If
so, you need to repair your rig. AND add a PTT buffer between the amp and
the rig so it does not happen again.

The PTT line of the SB220 has a .01 or .02 uF cap across the plug. When the
transceiver keys the amp, the relay in the rig must short out the .02 uF cap
and this causes a pretty big arc across the relay contacts of the rig. 

73

Jim W7RY

  ----- Original Message ----- 
  From: Alfred Frugoli 
  To: amps@contesting.com ; YCCC 
  Sent: Saturday, November 08, 2008 8:23 PM
  Subject: [Amps] SB-220 saga continues


  Hello everyone,

  So it seems I've got a problem with my SB-220.

  When the amp is off, but connected in the RF path, everything is fine.

  When I switch the amp on I've suddenly got lots of attenuation happening
on
  the receive path.  Transmit seems fine - amp tunes OK etc.

  My first suspicion was that there were dirty relay contacts on the receive
  side.  Cleaned the contacts with no success.  Then I realized that the
  problem only occurs when the amp is on.  So a trip to the schematic tells
me
  I don't understand.  In the RX mode the RF path through the amplifier
should
  be the same as when the power is on.  So I'm not sure where my attenuation
  is coming from.

  Just testing it a few minutes ago I can make an S5-7 station almost
  completely disappear by turning on the amp, so I've got somewhere in the
  area of 20db of attenuation happening!

  Thoughts?

  Thanks.

  73 de Al, KE1FO

  -----
  Visit my amateur radio contesting blog at ke1fo.wordpress.com.
  _______________________________________________
  Amps mailing list
  Amps@contesting.com
  http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>