I have an AL-1200, which puts out varying amounts of RF, with varying
efficiencies across the bands. I have also noticed this on mu LK-500ZB.
Here's what the AL-1200 does:
Drive is probably 105 watts.
CW Power out max in SSB position:
Band Po Ip Ig Pi Ef HV
Comments
160 1300 740 210 2390 54 3230
1912kHz (<Bird range)
80 1520 760 240 2470 61.5 3250
3792
40 1450 740 220 2368 61.2 3200
7072
20 1320 710 205 2293 57.5 3230
14152 (even across band)
15 1450 775 255 2495 58 3220
21300
10 1350 775 255 2495 54 3220
28500
And my LK500ZB does this:
Band Freq Load Tune Po Ig Ip
160 1845 95 66 1000 210 940
80 3700 65 85 1400 225 940
40 7.15 55 43 1280 215 860
20 14.2 55 28 1200 230 870
15 21.3 34 17 1150 210 860
10 28.45 20 9 1300 250 1000
It's not just rolling off with frequency, as both of them can do more on a
higher band than their minimum. (AL-1200 does 130W more on 15 than 20; LK-500
does 150W more on 10 then 15)
What causes this variation?
-Tony, K1KP
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|