Amps
[Top] [All Lists]

Re: [Amps] SB-220 and Xfrmr Smoke...Part 3

To: amps@contesting.com
Subject: Re: [Amps] SB-220 and Xfrmr Smoke...Part 3
From: Jeff Carter <amps@hidden-valley.com>
Reply-to: amps@hidden-valley.com
Date: Wed, 4 Feb 2009 17:14:42 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Folks, I've created a little bit of confusion by not being plain enough.

Sometimes, a picture is what's required.  I've been documenting this
rebuild at http://www.kd4rbg.com and I hope that those of you who I
confused will be able to see what's going on.

If need be, I can remake a picture if something isn't clear.  Where
possible, everything is Heath original.  Where a common component was
called for, I bought them from Mouser or Digi-key.  I have made a big
effort to document any departures from the original Heathkit
instructions.

Thanks for all the help,

Jeff/KD4RBG

---- Original message ----
>Date: Wed, 4 Feb 2009 13:38:18 -0800 (PST)
>From: Donald Fox
>Subject: Re: [Amps] SB-220 and Xfrmr Smoke...Part 2
>To: amps@hidden-valley.com
>
>Hi Jeff:
>
>So what you are saying is this the xformer is an unknown??
>
>In that case, I vote for the xformer as well. Hope you did not get taken
>too badly on it.
>
>I remember when you could buy those xformers new for not a whole lot.
>Makes me wish I had a closet full of them
>
>Good luck with your project.   BTW, what do you have there?? A single
>bander or a multi??
>
>I assume HF?
>
>                                              Don
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [Amps] SB-220 and Xfrmr Smoke...Part 3, Jeff Carter <=