I gave up looking for the right sizes and make my own. A bit of steel, a
shear and threaded rod. Roll the top and braze or weld on the rod. A bit
of paint and youre done.
Another way that comes to mind for a basic basement job is 3 aluminum,
brass or steel strips, 2 for the sides and a top piece. Threaded rod top
and bottom and some of that super strong epoxy.
Carl
KM1H
----- Original Message -----
From: "Roger Parsons" <ve3zi@yahoo.com>
To: "Amps" <amps@contesting.com>
Sent: Thursday, March 19, 2009 7:50 PM
Subject: [Amps] Clips for oil-filled capacitors
>
> After looking at the nice pictures of YC156 amplifiers, my mind
> wandered to the large oil-filled capacitors. The capacitors themselves
> are easy enough to get, but does anyone know of a source for the
> mounting clips? (The ones that clip over the top edge of the capacitor
> and are bolted to the chassis at the bottom.)
>
> Thanks
>
> Roger
> VE3ZI
>
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|