Drive punches and V-blocks
You need to set up a support on the shaft between the wafers and drive
out the pins with either a small arbor press or HIGH QUALITY punches
think Starrett not Harbor Freight. HF V blocks would be Ok as you
will need to cut them to fit.
- Scott
N7KA@comcast.net wrote:
> What are the SUCCESSFUL techniques for removing the pin in the rotor of these
> switches? IF YOU HAVE SUCCESSFULLY removed these pins I would like to know
> how it was done and what tools were used. I have some Model 86 switches I
> WANT to build/rebuild for use.
>
>
>
> Arne N7KA
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|