| To: | amps@contesting.com |
|---|---|
| Subject: | [Amps] Gettering 572B |
| From: | Larry K4AB <larry.k4ab@gmail.com> |
| Date: | Sat, 20 Jun 2009 20:56:03 -0500 |
| List-post: | <amps@contesting.com">mailto:amps@contesting.com> |
I noticed when gettering a new set of 572B's that I was drawing about 200mA Ip during standby. I quicky turned off the juice. Questions: 1) Should I continue the gettering with the plate caps removed? 2) Is gettering even necessary with high quality tubes? 3) Are,(at least one of tubes) bad? 73, Larry K4AB _______________________________________________ Amps mailing list Amps@contesting.com http://lists.contesting.com/mailman/listinfo/amps |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: [Amps] Checking relay timing with a scope, Paul Christensen |
|---|---|
| Next by Date: | Re: [Amps] Checking relay timing with a scope, Bill, W6WRT |
| Previous by Thread: | [Amps] Checking relay timing with a scope, Pete Smith |
| Next by Thread: | [Amps] Gettering 572B, John Lyles |
| Indexes: | [Date] [Thread] [Top] [All Lists] |