Amps
[Top] [All Lists]

Re: [Amps] 3-500Z viable after long storage?

To: audioguy@charter.net
Subject: Re: [Amps] 3-500Z viable after long storage?
From: Jim Barber <audioguy@charter.net>
Reply-to: audioguy@charter.net
Date: Sun, 09 Aug 2009 23:36:07 -0700
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Or, how about putting 50M in series with each anode cap and then 
monitoring the anodes for voltage drops? (arcs) I don't know if limiting 
the current that severely would allow arcs that might occur to eat any 
gas molecules anyway, but I thought I'd throw it out there.

Jim, N7CXI

Jim Barber wrote:
> The Henry 3K-A I just picked up (loooonnnggg drive!) has a set of what 
> were 12 years ago "fresh" 3-500Z's with it. The amp and tubes have been 
> sitting in the OM's nice, warm, dry shack for 12 years with no power 
> applied. He never got around to pulling 240V into the new shack after he 
> moved.
> 
> The question is should I try them? There's no high-pot tester available 
> locally that I know of. My fear, of course is that one or both might be 
> gassy and flash over, potentially damaging the HV supply.
> 
> Thanks,
> Jim, N7CXI
> 
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
> 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>