Last weekend, I went to my local library to look at some recent issues of QST
magazine for April through July of this year.
By mistake, the librarian brought me the issues from 2008 instead of this year.
In one of those issues, there was an article about converting the SB 220 to
six meters. I cant remember right now with of those months, but it was one of
them .. April, May, June or July of 2008.
> Date: Tue, 11 Aug 2009 15:06:32 -0700
> From: w0jx@yahoo.com
> To: n1miw@cox.net
> CC: amps@contesting.com
> Subject: [Amps] SB-200 vs SB-220 Conversion for 6 Meters
>
> FWIW:
> Early this Spring, I started to convert my SB220 to 6 meters. It became more
> complicated than I wanted (i wanted an easy reversal back to the original) so
> I abandoned my efforts and turned to my SB200 for a 6 meter conversion. It
> was easy and has worked well.
>
> The conversion of the SB200 to 6 meters took less than 4 hours. I pulled the
> plate tuning cap and replaced it with an old Bud 55 pf unit I had in my junk
> box. I also removed the 10-20 meter coil (left the 80/40 coil in place) and
> wound a new 2 1/2 turn coil from a copper thermocouple. To reduce stress on
> the bandswitch, I jumped the switch contacts with a piece of copper ribbon.
> The plate coupling cap is mounted directly on the plate variable.
> One important change is to disconnect one section of the loading capacitor.
> It makes it much easier to tune and is easily reversible.
>
> I removed one turn from each parasitic suppressor per W7MY's web page. For
> the input, I tack soldered a 50 pf mica cap on the cathode side of the ten
> meter input coil and a 68 pf capacitor on the input side. The SWR came right
> on down to almost 1 to 1. The stock antenna relay does not seem to be a
> problem. There is a slight bit of instability without an input coax connected
> but once the amp was connected to my Icom 706, it was unconditionallly
> stable.
>
> I get 725 watts out with about 80 watts of drive from the IC706. Signal
> reports have been excellent with no distortion reported. I key the amp with a
> footswitch to avoid any issues with the relay system in the 706.
>
> I highly recommend the SB200 for conversion to 6 meters as long as it has the
> Cetron tubes. I have no experience with the Chinese 572B's. My grid and plate
> current meters read in the normal ranges.
>
> I have photos of the plate compartment and cathode coil if anyone is
> interested.
>
> 73, Dennis W0JX/8
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|