That was an interesting read. Thanks for sending the link.
Randy AB9GO
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of DF3KV
Sent: Friday, September 18, 2009 2:58 PM
To: amps@contesting.com
Subject: Re: [Amps] Vacuum variable hipot
I think that is still normal.
The 5KV rating normally is the peak AC test voltage rating at maximum
capacity, not the working voltage.
When those are stored for a longer time the vacuum might not be perfect
anymore, so it´s a good idea to calculate for safety margin on the voltage
requirement.
Only very few of probably 100 surplus capacitors I tested did not show
leakage current near the rated voltage or took higher voltages without
current flow.
Most failed at much lower voltages.
See also:
http://www.comet.ch/files/webcontent/servicebulletins/sb_28.pdf
73
Peter
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Steve
Sent: Freitag, 18. September 2009 13:03
To: amps@contesting.com
Subject: [Amps] Vacuum variable hipot
I have a Jennings UCSL1000 - 1000pF, 5kV cap. If I put 5kV dc across it
and run it through its tuning range, the leakage current is sometimes
zero but fluctuates and there are places where the current leaps up to
50uA. At those points the current falls to zero if the voltage is
reduced to around 4kV, although I have heard a couple of arc 'pops' from
it sitting there at 4kV.
At other settings where the current is lower, 5uA or less, the leakage
dies away to zero if I leave it sitting there for a while.
Is this normal behaviour? Is this one a duffer?
Thanks,
Steve
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
Confidentiality Notice: This e-mail message, including any attachments, is for
the sole use of the intended recipient(s) and may contain confidential and
privileged information. Any unauthorized review, use, disclosure or
distribution is prohibited. If you are not the intended recipient, please
contact the sender by reply e-mail and destroy all copies of the original
message.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|