Assuming the item is otherwise clean:
One relatively low-risk method is to line a glass dish with aluminum
foil, then soak the item in a heated (boiling or close) preparation of
1/4 cup ordinary baking soda to a gallon of water.
Don't leave the item in longer than necessary. (usually 5-20 minutes
gives maximum effect, or until the water cools) Rinse well with clear
water, blow off with compressed air if available and let air-dry
overnight. Discard the used solution.
Note the aluminum foil mentioned above is a necessary component of the
process.
My .02,
Jim, N7CXI
Pete Raymond, N4KW wrote:
> I have an Eimac SK-800B socket that I would like to clean up and remove the
> tarnish etc. Any suggestions as to the best method to do this.
>
> Also looking for three toe clamps used to mount the SK-800B.
>
> 73 Pete N4KW
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|