Hi All,
Just picked up this amp and need to install a 10m input pi network, to
include the switching relays, trim caps and wind the10m toroid. The rest
of of the stuff is pretty much straight forward. (tap the tank, run
wires from band switch to the input board, etc.)
Question; Have any of you done this before on this amp? If so, do you
have any values for the components? If you have one and it already has
the 10m option, maybe you could look on the input board and get the values.
Any help or advise on where to get/go for information would be greatly
appreciated.
Thanks in advance,
Steve AB5MM
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|