No, I haven't seen that problem. If you end up having to call Autek,
I hope you have more luck than I did.
I have a RF-5 that lost calibration and called down there, and Autek
seems to be a one man shop, and the one man doesn't seem to have very
many good days.
It was cheaper to pick up another RF-5 off eBay than fix the one I had.
I still maintain that Autek stuff is good and I use it, I just won't
bother to try to get anything else repaired through them. I'll
consider each box a throwaway item.
Jeff/KD4RBG
On Sat, Oct 10, 2009 at 9:47 AM, Charles Harpole <k4vud@hotmail.com> wrote:
>
> Hey, after extolling the virtues of the Autek WM-1 wattmeter, I developed a
> problem
>
>
>
> with mine. At full power, the remote sensor stopped passing RF, incoming or
> outgoing.
>
>
>
> I thot I had this problem on earlier occasions, but wrote those off to
> defective coax plugs.
>
>
>
> Now, I am sure.... the blasted thing failed and likely has several times
> before but I did not
>
>
>
> check completely. Now I have. Anyone else see this problem? Opening the
> sensor box
>
>
>
> shows nothing out of order!!! 73,
>
>
>
> Charles Harpole k4vud@hotmail.com
>
>
>
>
>
>
>
>
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|