That amp uses electronic bias control, maybe something is needed to
activate.
Carl
KM1H
----- Original Message -----
From: "Roger" <sub1@rogerhalstead.com>
To: "Phil LaMarche" <plamarc1@verizon.net>
Cc: <amps@contesting.com>
Sent: Sunday, October 25, 2009 5:43 PM
Subject: Re: [Amps] AL 80B
>
>
> Phil LaMarche wrote:
>> Just received this amp and wondering if ALC must be hooked up as asked in
>> the manual. I haven't used ALC in years. When I key the Amp, I'm not
>> getting any power out. Relay is closing. Any one help?
>>
> How about removing the ALC line and just applying a "little carrier" for
> drive?
>
> It's probably something simple with a new amp and as Steve said, a bit
> more information is in order.
> Follow the instruction manual carefully. There may be shipping
> preparation that has to be removed.
>
> 73 and good luck,
>
> Roger (K8RI)
>>
>> Phil
>>
>>
>> Philip LaMarche
>> LaMarche Enterprises, Inc.
>> <http://www.instantgourmetspices.com/> www.instantgourmetspices.com
>>
>> www.w9dvm.com <http://www.w9dvm.com/>
>> 800-395-7795 pin 02
>> 727-944-3226
>> FAX 727-937-8834
>> NASFT 30210
>>
>> K3 #1605
>>
>> CCA 98 00827
>> CRA 1701
>>
>> W9DVM
>>
>>
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|