Hey amp builders,
As a general rule, what would be considered "good" regulation and good
ripple of an HV power supply?
If the no load voltage for a 3cx800A7 amplifier's power supply is 2500 V, while
the fully loaded voltage is 2100 V @ 1A, is that "good"? Is it good enough?
What about the ripple, what is acceptable? For the above, using 330 uF
capacitive input filter and a full wave bridge, the ripple is calculated to
about 25V p-p. Is that "good enough"
thanks,
Paul (KG7HF)
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|