Amps
[Top] [All Lists]

Re: [Amps] LK-500NT issue

To: "R. David Eagle" <kb8nnu@yahoo.com>, "amps@contesting.com" <amps@contesting.com>
Subject: Re: [Amps] LK-500NT issue
From: "Fuqua, Bill L" <wlfuqu00@uky.edu>
Date: Sun, 7 Feb 2010 14:35:16 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Unless something went wrong with the SWR meter I would suspect one of two 
things happened. One a HV discharge in the RF section produced a high energy 
impulse (lots of frequencies) that was detected by the reflected power detector 
and thus a very short term high SWR reading.  If it had been in the power 
supply it would have been filtered out before getting to the SWR meter. 
   The second is a VHF parasitic or even an out of band HF parasitic 
oscillation.  Either would be out of the frequency range of your antenna system 
and produce a high SWR.
   Now back to the opening statement about the SWR meter. If your SWR meter is 
an active device that has amplifiers and other electronics in it a transient in 
the power supply that somehow propagated to the swr meter and made it go 
bonkers is possible. 
   Maybe a spider wove a web in the wrong place and it is history now. 

73
Bill wa4lav

_______________________________________
From: amps-bounces@contesting.com [amps-bounces@contesting.com] On Behalf Of R. 
David Eagle [kb8nnu@yahoo.com]
Sent: Sunday, February 07, 2010 12:45 PM
To: amps@contesting.com
Subject: [Amps] LK-500NT issue

Hello all...During the 160 contest last weekend, mr Murphy decided he would 
stop by and shut my amp down thus forcing me to run barefoot on 160 during the 
contest!  While I was calling CQ, I heard a pop noise from my amp and noticed 
my SWR went to infinity on the rig and I lost my grid/plate current.  I've been 
diggin through it this last week and have found absolutely nothing wrong.  I am 
still getting about 3300 plate voltage so I will assume the HV power supply is 
good.  The tubes are lit so the filament transformer is working.  As far as the 
high SWR issue goes, I went through the TR switching and that seems to work 
fine.  Then I seperated the tuned input from the TR switch and check that with 
my antenna analyzer and that seems to be passing RF fine on all bands.  I also 
checked the shunt resistors and they look fine too.

So does anybody out there in amp land have any suggestions/tips....alcohol... 
for this issue?

Thanks,

Dave
kb8nnu



_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>