James Colville wrote:
> Mouser has these:
>
> http://www.mouser.com/catalog/catalogUSD/641/670.pdf
>
I like the 600 watt and 1000 units meant to be mounted on heat sinks.
They are not inexpensive, but when compared to other high power
resistors they don't look terribly expensive. They are also small enough
to build a high power dummy load that'll go past 2-meters. However it'll
take some good heat sink compound to make them reach their power
ratings. Like the high power transistors, the problem is getting the
heat transfer good enough to lower the delta T to the point where they
can really work.
It looks like a pair of the 600 Watt, 100 ohm units in parallel would be
close to half again the heat transfer area for one of the 1000 watt
units. 13.6 sq in for 2 100 ohm, 600 watt units Vs 9 sq in for one 1000
Watt unit. = 51% increase in contact area. $227 compared to $142. I
think I'd opt for the more expensive approach with a big heat sink and
good fans, or water cooled heat sinks using cold water.
73
Roger (K8RI)
> They also have others. See their catalog pages 656 to 670.
>
>
> 73
> Jim W7RY
>
>
>
> On Thu, Feb 18, 2010 at 7:08 PM, R. David Eagle <kb8nnu@yahoo.com> wrote:
>
>
>> Hello all....
>>
>> I was wondering if there is a good source of resistors out there that could
>> be used in building a dummy load that will handle a KW....????
>>
>> Any suggestions welcome
>>
>> Thanks,
>>
>> Dave
>> KB8NNU
>>
>>
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|