Amps
[Top] [All Lists]

Re: [Amps] soft start, how to determine if needed?

To: Ham-amps <amps@contesting.com>
Subject: Re: [Amps] soft start, how to determine if needed?
From: Herzog <herzog@frontiernet.net>
Date: Tue, 02 Mar 2010 00:05:27 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Herzog says there is confusion.
There are thermistors of a type that measure 25 to 100 ohms when cold, 
and drop to an ohm or two when hot.
   My last one has been keeping my outdoor light, 25 feet up under the 
eves, working for 35 years.  I also have a diode in series so runs soft 
light.  I just don't want to climb up there anymore.
The diode causes the motion sensor relay to build up a stalagmite or 
some such, but tapping it with a liter bottle frees that sticking up 
every few years.  K2LB
=========
RE:  On Sun, 28 Feb 2010 09:58:56 +0200, "Alex Eban" <alexeban@gmail.com>
wrote:

 > >By the way, an old trick that was used in tube type TV sets was to 
install a
 > >thermistor in series with the mains.

REPLY:

That thermistor was not used for soft start. It was part of the
degaussing system and had very poor reliability. I changed hundreds of
them over the years. Not recommended.

73, Bill W6WRT
===============

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>