> ORIGINAL MESSAGE:
>
> On Wed, 7 Apr 2010 04:45:06 -0700, "Jim Thomson" <Jim.thom@telus.net>
> wrote:
>
>>## what SWR ? There isn't any. The connectors would flash
>>over if there was any amount of swr.
>
> REPLY:
>
> If there is no transmission line then by definition there can not be
> any SWR, but there still can be an impedance mismatch between the
> tube's plate load impedance and the antenna's feedpoint impedance.
>
> 73, Bill W6WRT
Not if the Pi Net is doing its job.
Carl
KM1H
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|