He later retracted that design saying it was not workable in actual dynamic
use.
Carl
KM1H
----- Original Message -----
From: "Mike Lucas" <W5CHR@Bellsouth.net>
To: <amps@contesting.com>
Sent: Friday, April 16, 2010 7:56 PM
Subject: [Amps] Grounded grid matching circuit
> In the March 1978 HAM RADIO magazine, Ulrich Rohde wrote about an
> elliptic filter covering the amateur bands
> from 1.8 to 30MHz, suitable for an input circuit to an amp needing a 50
> ohm to 100 ohm stepup. A corrected
> schematic was published in the August 1978 SHORT CIRCUITS. I have run
> the numbers through Jim Tonne's
> software, and the results (both the original circuit and the corrected
> one) don't look anywhere near flat enough to
> work. VSWR is wild and off the charts! I'd bet good money that Rohde
> was right and I blithered somewhere, but
> I haven't found where yet. Has anyone in the audience seen the article,
> and what were your conclusions?
> Anyone? Anyone?
>
> Mike W5CHR
> Memphis
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|