In a thread a couple of months back, there were comments about keeping RF
out of the stack of electrolytics in a power supply. The suggestion was to
bypass the stack with a .001 MFD HV disc.
Does it matter if you bypass the stack directly across the electrolytics
(plus to minus), or from plus to GROUND? The difference is that there's
usually a 50 ohm 50 watt (or something) resistor between negative and ground.
Steve Gilbert
K1SG
K1SG@AOL.com
508-435-9133
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|