Terminate the "unused" rig in a dummy load capable of handling full
power from the rig. It's a matter of protection in case anything
goes wrong and the unused rig is accidentally put in transmit!
73,
... Joe, W4TV
On 12/18/2010 3:01 PM, Allan Greening wrote:
> When using a dual coax relay is it better to terminate the unused port into
> a short or into a 50 ohm load??
> I am using a dual 4 port coax relay to feed 2 radios into a common amp, so
> should I terminate into short to gnd or a 50 ohm load? 1 radio goes to the
> amp es other is shorted to gnd es the other way round when relays are
> keyed!!
> 73 es Dxis vk3pa
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|