Hello all,
I have on the way a Fluke 80K-6 HV probe. It is only rated to CAT I and from
the text below it may not be suitable for measuring the B voltage of a linear
amp esp. one with a large filter cap. Should I be using something rated CAT
III?
The 80K-6 is a high voltage probe designed to extend the voltage measuring
capability of an AC/DC voltmeter to 6000 volts peak AC or DC Overvoltage
Category I. This means the probe can only be used to make measurements on
energy limited circuits within equipment. Examples include high voltage within
televisions or photo copy machines.
Thanks
Randy AB9GO
Confidentiality Notice: This e-mail message, including any attachments, is for
the sole use of the intended recipient(s) and may contain confidential and
privileged information. Any unauthorized review, use, disclosure or
distribution is prohibited. If you are not the intended recipient, please
contact the sender by reply e-mail and destroy all copies of the original
message.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|