Jim
I think something has been lost in the translation !
It is being suggested that you should use a new core, because the old one
may have been saturated and/or overheated and it's properties have changed.
John G4ZTR
-----Original Message-----
From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
Behalf Of Jim W7RY
Sent: 26 January 2012 02:47
To: Carl; amps@contesting.com
Subject: Re: [Amps] 3CX800A7 Grid Current Problem
Carl... How would just re-winding the core fix anything?
Please explain?
Thanks
73
Jim W7RY
> If the toroid is the problem the easiest solution is to remove and wind a
> new toroid with better insulation on the core and wire as there is no
> simple
> way to undo the engineering problems without spending a lot of money. If
> the
> 4:1 looks the slightest bit cooked then make a new one also.
>
> As long as your input VSWR and power is holding steady I dont think that
> circuitry has a problem but they are also known for cooking relays.
>
> Carl
> KM1H
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
__________ Information from ESET NOD32 Antivirus, version of virus signature
database 6833 (20120127) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
__________ Information from ESET NOD32 Antivirus, version of virus signature
database 6833 (20120127) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
__________ Information from ESET NOD32 Antivirus, version of virus signature
database 6833 (20120127) __________
The message was checked by ESET NOD32 Antivirus.
http://www.eset.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|