Take a very close look at the bandswitch contacts that are connected to those
switched caps.
On 2/8/2012 6:33 PM, Tom Osborne wrote:
> Hi All.
>
> I have a SB-200 and it developed a problem in the last week or so.
>
> When tuning up on 40, the Load cap is all the way meshed and the Tune cap is
> about 50% meshed. It puts out about 400 watts on 40. On 40, the input SWR
> is 1:1.
>
> In 80 the Load cap is all the way meshed. It puts out about 200 watts. The
> input SWR is 1:1.
>
> I checked to make sure the 2 sections of the Load cap were soldered together
> OK and they are. I disconnected the cap that is switched in on 80 and
> replaced it with another one and still doing the same thing.
>
> If the tubes are going soft, will it affect the tuning like that? Seems
> like I've replaced the tubes before but never had the problem of the Load
> cap being all the way meshed to load on 40. Thanks and 73
> Tom W7WHY
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
--
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco/
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|