10-4 good buddy
----- Original Message -----
From: "kennon lewis" <saveatpharmacy@gmail.com>
To: <amps@contesting.com>
Sent: Thursday, February 16, 2012 2:58 AM
Subject: [Amps] 3-500 to 4-250 tube conversion
> hello. recently I received an amplifier with 6 bad 3-500z tubes in it. i
> have a bunch of good 4-250 and 4-400 tubes on hand and am looking to
> convert the amp to run on these tubes. the cost of purchasing 6 new 3-500
> tubes is out of the question at this time. the amp covers 10 - 80 meters.
> looking at the tube data it looks like all i need to do is strap pins 2
> and
> three together with a low ohm resistor and that should do the job, one
> being a triode and the other a tetrode. the power supply seems more than
> adequate. any schematic help or other information will be greatly
> appreciated. thanks ke5rgm
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2112/4813 - Release Date: 02/16/12
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|