Ive been using those for ham and commercial repeaters here from 223 to 1290
MHz and bought directly from W8ZD. They still do a good job contrary to the
negative comments on that site.
My only complaint was they were made only for 3/4" hardline and I had a lot
of 7/8" and 1" I used for my own VHF/UHF weak signal antennas. I then made
my own adapters that were far less work than on that site.
Carl
KM1H
----- Original Message -----
From: "Ron Youvan" <ka4inm@tampabay.rr.com>
To: "amps" <amps@contesting.com>
Sent: Friday, March 09, 2012 6:11 PM
Subject: Re: [Amps] 6kW coax?
> Carl KM1H wrote:
>
>> But what do you use for connectors at that power level in a commercial
>> environment?
>
> Here's a 500 Watt version:
> http://www.repeater-builder.com/projects/matchingstubs.html
>
>>> Commscope 1125 is what comes to mind,check it out.
> --
> 73 Ron KA4INM - All E-mail sent to this address shall linger in the
> Google cloud forever!
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2113/4860 - Release Date: 03/09/12
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|