I am putting a new coil in my amp's Pi-Net.
I am going to use the MFJ259b on the output to find the coil taps (as I did
a few years ago) but I've forgotten some set-up details.
For my 3x813's, my notes indicate I used a 2200-ohm load resistor to
simulate the plate load which connects between the tube side of the blocking
cap and chassis ground.
My questions are - do I leave the tubes in circuit? Do I leave the plate
choke in circuit?
Thanks,
Steve KK7UV
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|