I had so many problems with a Paragon and later an Orion that I just sent
them back for whatever refund they wanted to give me. Luckily I kept the
TS-930 and then the TS-940 and have completely removed Ten-Tec from any
consideration.
I also get a fair number of their amps in to repair.
Carl
KM1H
----- Original Message -----
From: "Colin Lamb" <k7fm@teleport.com>
To: "Mark K5AM" <k5am@zianet.com>; <amps@contesting.com>
Sent: Monday, August 27, 2012 12:54 PM
Subject: Re: [Amps] Solder flux
> "Why is new solder better?"
>
> Many years ago, my Ten-Tec Paragon PLL failed. A call to Ten-Tec tech
> informed me that was a common problem, due to bad wave soldering on the
> PLL boards. He recommended sucking all of the solder out and resoldering.
>
> Thinking I was smarter than the Ten-Tec tech, I carefully resoldered each
> joint on the board. Unfortunately, I still had the same problem.
> Defeated, I did as told and removed the solder from each joint and
> resoldered. And, yes it worked perfectly, and is still working.
>
> I still do not understand why the resoldering did not work - but from this
> point, I remove the old solder as Carl does.
>
> 73, Colin K7FM
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1424 / Virus Database: 2437/5227 - Release Date: 08/27/12
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|