2100 is about right in standby on CW while 2600-2700 is fine on SSB.
I hope its just out of tolerance metering resistors and not the filter caps
loading it down with high leakage.
Carl
KM1H
----- Original Message -----
From: Tim Kass
To: Carl ; amps@contesting.com ; Colin Lamb
Sent: Friday, September 07, 2012 11:53 AM
Subject: Re: [Amps] Dentron 160-10L 10 meter issue
Thanks Carl, well, only driving it with about 75 watts, wont go over
that with my 746PRO to keep it happy...and not trying to sqeeze every last watt
out either, like some folks.. ;) When I rebuilt the power supply, could have
redone that voltage doubler circuit, since it uses the same transformer at the
Clipperton L, but didnt want to push the 572B's either, 2100 volts at idle now.
So will just be careful and tune very slowly on the Tune knob, hate to write in
tune positions but maybe stick some colorful tape on the exact loading
spots..hi hi ...geez..its a junk style amplifier anyway and I've already cut up
and modified it so much..don't think I can hurt the value of this amp any
more..hi hi
73, Tim K8WBL
--- On Fri, 9/7/12, Colin Lamb <k7fm@teleport.com> wrote:
From: Colin Lamb <k7fm@teleport.com>
Subject: Re: [Amps] Dentron 160-10L 10 meter issue
To: "Carl" <km1h@jeremy.mv.com>, "Tim Kass" <k8wbl@yahoo.com>,
amps@contesting.com
Date: Friday, September 7, 2012, 11:31 AM
"Id start there and in the CW position and tune for maximum smoke."
Careful, Carl, there are a lot of hams out there who take every word
as gospel and will try to do that.
73, Colin
------------------------------------------------------------------------------
No virus found in this message.
Checked by AVG - www.avg.com
Version: 10.0.1424 / Virus Database: 2437/5254 - Release Date: 09/07/12
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|