Earlier this week, I posted on here that my QSK device (QSK-1) was
malfunctioning.
Thanks for all the replies, but I was wrong. After further inspection, it now
appears that it is indeed the AL-811.
I purchased the amp new last spring. It is still in warranty, but I am
wheelchair bound and would really prefer to repair it myself since getting it
to the shipper would be difficult.
Anyway here is the situation.
The amp powers up, 1700 volts plate voltage, about 60 ma plate current no
drive, xmit light comes on and the relay does energize. This occurs on all
bands. The filaments light up. The Load and Plate controls have very little
effect on anything. They will and do change the meter readings but nothing in
regard to the output. I may get about 10 watts out over my drive power.
I have probably missed something, but any ideas out there anywhere?
Tom K5IID
-- Just because you do not take an interest in politics doesn't mean politics
won't take an interest in you!
Pericles (430 B.C.)
"Socialism is a philosophy of failure,
the creed of ignorance, and the gospel of envy,
its inherent virtue is the equal sharing of misery.."
-- Winston Churchill
"Democracy depends on well-informed voters; absent that, it is all mud flowing
down hill."
--Charles Harpole
"Luck is a dividend of sweat. The more you sweat, the luckier you get."
If you don't like my signature? Too Bad! But I will use it because it is what I
believe.
K5IID Tom Horton Hillsboro, TX
E sorter for ARRL W5 bureau
Same call for 55 years!
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|