Amps
[Top] [All Lists]

Re: [Amps] LK-500Z output on 10m

To: amps@contesting.com
Subject: Re: [Amps] LK-500Z output on 10m
From: Vasiliy - K3IT <gokoyev+k3it@gmail.com>
Date: Fri, 1 Feb 2013 12:59:22 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Sorry, I jumped the gun. Getting a good output now with the LOAD set to an
"off the dial" setting.  Not sure about the service note, may be they meant
it for unmodified amps.

73

On Fri, Feb 1, 2013 at 12:40 PM, Zev Darack <zevdarack@gmail.com> wrote:

> This doesn't sound right.  I get 1000 out on 10 from my 500zc.  are you
> sure the mod was done right?
>
> n2wks
>
> On Thu, Jan 31, 2013 at 11:37 PM, Vasiliy - K3IT 
> <gokoyev+k3it@gmail.com>wrote:
>
>> I'm looking for some info on what should be a typical output for the
>> LK-500ZB amp on 10 meters.   I'm getting 1200W easily on all bands except
>> 28Mhz.  The 10m mod is installed.  There was the following note included
>> with amp (from a person servicing them professionally):
>>
>> > tests produced a measured output of at least 1,000 carrier watts EXCEPT
>> 10 meters, which would only produce about 240 watts out due to design
>> limitations of the pi network.  It is not recommended 10 meters be used
>>
>> does it sound right?
>>
>> 73
>> Vasiliy
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>>
>
>
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>