Try switching the PEP and the power range switches through a few cycles; a tiny
bit of contact oxidation makes the WM-1 really act up and read erroneously, but
just operating the switches through a few cycles usually fixes that.
73
WB2WIK
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Charles Hedrick
Sent: Sunday, February 17, 2013 12:33 PM
To: amps@contesting.com
Subject: [Amps] Autek WM-1 calibrated....
Hi all I'm having an issue and I think that it's the wall wort. The meter
tested fine at low power on the test bench.....300 watts. When I put it in
line on the station with an excellent station ground(ex combat comm) the meter
reads some 400 watts higher PEP than the Alphas internal LED's read.
I'm thinking RF is being picked up on the power cord from the wort to the meter.
any other ideas?
Cam
WA4JKW
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|