Amps
[Top] [All Lists]

Re: [Amps] FW: Power factor correction on tube amps

To: Bill Turner <dezrat1242@yahoo.com>, Amps <amps@contesting.com>
Subject: Re: [Amps] FW: Power factor correction on tube amps
From: Bill Fuqua <wlfuqu00@uky.edu>
Date: Fri, 8 Mar 2013 17:39:45 -0500
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Until recently, past 20 or 30 years transformers have been either treated as devices in signal level circuits or in simple power circuits that did not include rectifiers. Most power electronics only considered resistive, and motors ( reactive devices requiring power factor correction).
Also, power transmission and that was about it.
  73
Bill wa4lav


At 07:03 PM 3/7/2013 -0800, Bill Turner wrote:
ORIGINAL MESSAGE:
On Thu, 07 Mar 2013 16:59:40 -0800, Jim wrote:

>
>The equivalent circuit of a transformer is complex -- in addition to the
>leakage inductance, there's resistance in the wire, resistance coupled
>from the core, capacitance between turns, capacitance between windings.
>At power frequencies though, we don't see the inductance or capacitance,
>only the resistance. And if we look into one winding, we see the load
>impedance on the other winding multiplied by the square of turns ratio.

REPLY:
Jim is right. Transformers are deceptively simple as taught in first
semester electronics. In fact, they are among the most complex of all basic
electronic devices. Time spent hitting the transformer books is well spent.
73, Bill W6WRT
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>