Hi Mike....
Yes, both the 240VAC connectors as well as the 50VDC and control pins
connectors are available....tho not without some work.
Here is an embedded Word doc for easier reading for you.
I have a few of these connectors available if you'd rather not do the work
of acquiring the backplanes and then removing the connectors.
They are $15 for the pair plus shipping.
73,
Dick, K5AND
Austin, TX
"There are two 'blade enclosure' units which can be salvaged for connectors
etc.
274840-001 and 230769-001; the first one is a single phase unit and the last
one is 3 phase.
The only problem is that these things are big, heavy and come with bulky
cabling attached.
The DC output with its integral 20 pin control is easier to obtain by simply
buying the 253381-001 backplane assembly.
This will provide six DC output connectors as well as six 20-pin control
connectors.
The 20-pin control connectors have to very carefully removed from the PC
motherboard.
They are NOT soldered to the board; rather, they have 'compression' pins
which have been forced into the board, thus making contact with the plated
thru holes into which they mount.
The tinned copper bus bar has to be cut out with a hacksaw, but once
removed, you wind up with dandy heavy duty connecting lugs"
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of
mikflathead@aol.com
Sent: Friday, July 05, 2013 5:41 PM
To: amps@contesting.com
Subject: [Amps] Blade power supply
Is there an available connector to connect the input 220 and output 50 volt
connectors to the outputs of these type power supply.
A spade terminal kinda works but will not go on all the way do to the taper
on the male lug. Any creative ideas out there?
Thanks Mike
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|