It's quite close to the Eimac 3-1000 except for the lousy amplification
factor which will be a handicap from the drive requirements standpoint. The
-1000v is nothing just a design limit; in normal operation it will probably
require something around -50 t -100v V bias at a plate voltage of about 2500
V and proportionately higher with increasing anode voltage.
Use it only if you have no other choice.
-----Original Message-----
From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of Jeff Pederson
Sent: Saturday, December 14, 2013 4:05 PM
To: amps@contesting.com
Subject: [Amps] Is this tube anygood for a monoband 80meter GG amp
Good Day,
Well its been awhile since I posted to this list but read the posts. My
weakness is how to determne if this tube is suitable for use as a ssb amp
and does anyone have a tutorial or link on how to use the constant current
characteristic tube charts? That -1000v grid in the specs makes me think it
wont work or be practical but thats why Im asking.
http://www.ok1rr.com/tubes/Thales/T1000-1.pdf
Happy Holidays
Jeff
KD4LYH
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
http://www.avast.com
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|